Welcome to our new forum
All users of the legacy CODESYS Forums, please create a new account at account.codesys.com. But make sure to use the same E-Mail address as in the old Forum. Then your posts will be matched.
Close
i have a weird problem, recently we upgraded our codesys to version 2.3.9.25
since then i cant rename inputs/outputs in Resources / PLC Configuration
it gets weirder..in resources/plc configuration i have some modules under K-Bus (FIX) and there are also other modules connected with profibus
i cant rename only the ones under k-bus (those modules connected via profibus i can rename just fine)
before the upgrade i was able to rename by simple double-click
now i got a hint that i should right click on k-bus, append subelement and in the new window, tab ínput/output, i can rename there
well, i can enter new names for input/outputs also for modules under k-bus but when i click OK i get this error:
'The command could not be executed!'
any help please??? i don want to redo the whole thing, its HUGE!
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
did you name any outside contact inside an pou?
something like in1 at %IX0.1 :bool;
check if anywhere outside the global something is addressed.
or double address.
check all names for allowance like no spaces not starting with numbers etc.
check for double names
copy project and delete all cards and check if this is working, then you can check all the names.
If you would like to refer to this comment somewhere else in this project, copy and paste the following link:
Originally created by: tw0face
hey
i have a weird problem, recently we upgraded our codesys to version 2.3.9.25
since then i cant rename inputs/outputs in Resources / PLC Configuration
it gets weirder..in resources/plc configuration i have some modules under K-Bus (FIX) and there are also other modules connected with profibus
i cant rename only the ones under k-bus (those modules connected via profibus i can rename just fine)
before the upgrade i was able to rename by simple double-click
now i got a hint that i should right click on k-bus, append subelement and in the new window, tab ínput/output, i can rename there
well, i can enter new names for input/outputs also for modules under k-bus but when i click OK i get this error:
'The command could not be executed!'
any help please??? i don want to redo the whole thing, its HUGE!
did you name any outside contact inside an pou?
something like in1 at %IX0.1 :bool;
check if anywhere outside the global something is addressed.
or double address.
check all names for allowance like no spaces not starting with numbers etc.
check for double names
copy project and delete all cards and check if this is working, then you can check all the names.